• Balance tire pressure sensor (1) and
tighten the fixing nuts (2) of it to the valve
stem.
• Tighten the fixing nuts of the tire pressure
sensor 5 ±0.5N·m with 11mm socket
wrench.
• After the tire is refitted, inflate the tire and
spray soapy liquid to check if the tire is leaking. If
there is no air leakage, screw on the dust cap. If
the air leaks, find out the cause and re-assemble
it.
• After the assembly is completes, inflate the
tire to the standard pressure (inspect using the
tire pressure gauge).
• Refit the tires to the wheels. (See "Removal
and Refitting of Wheel" in Wheel section.)
• Match the tire pressure monitoring system
after the wheel is installed. (Refer to the "Tire
Pressure Learning" in this section.)
• When refitting the tire with the tire changer,
always keep the tire changer mounting head (1)
90° above the valve, otherwise the tire pressure
sensor may be damaged.
To Next Page
Loading...