Indoor temperature sensor
4.3-33
• Connect the ventilation pipe (1).
• Insert the indoor temperature sensor
connector (2) and ensure it is clamped in
place.
• Refit the instrument panel left protective
plate (3).
• Clamp the fixing brackets of the charging
hole cover handle and the drive motor
compartment handle in place and pre-tighten
the fixing bolts (1).
• Tighten the fixing bolts (1) of the charging
hole cover handle and the drive motor
compartment handle with a Phillips
screwdriver.
• Tighten fixing screws (1) of instrument panel
left protective plate with a Phillips
screwdriver.
• Refit the fuse box cover in the passenger
compartment.
• Refit the instrument panel left protective
plate (2).
• Connect the battery negative cable.
To Next Page
Loading...