Maintenance Section
-175-
Inspect Coolant Hoses (LP Engines Only)
1. Visually inspect coolant hoses and clamps.
Remember to check the two coolant lines that
connect to the pressure regulator/converter.
2. Replace any hose that shows signs of swelling,
cracking, abrasion or deterioration.
(1) LP fuel lock-off, (2) LP regulator/converter
(3) Fuel Trim Valve(FTV), (4) LP mixer
(5) Vacuum lines, (6) Coolant lines, (7) LP fuel line
LP Regulator/Converter Inspection (LP
Engine Only)
1. Visually inspect the pressure regulator/converter
housing(2) for coolant leaks. Refer to the pressure
regulator/converter section of the service manual if
maintenance is required.
NOTE: For pressure testing and internal inspection of
the pressure regulator/converter, refer to the
pressure regulator/converter section of the
service manual.
Fuel Lines & Fittings - Check
Visually inspect fuel lines and fittings for physical
damage. Replace as required.
Inspect Mixer Assembly (LP Engine Only)
Refer to the LP mixer section of the engine service
manual for procedures.
Inspect Throttle Assembly (LP Engine Only)
1. Visually inspect the throttle assembly motor housing
for coking, cracks and missing cover-retaining clips.
Repair and/or replace as necessary.
NOTE: Refer to the LP mixer and throttle section of the
service manual for procedures on removing the
mixer and inspecting the throttle plate.
1
7
2
3
6
https://www.forkliftpdfmanuals.com/
To Next Page
