Maintenance Section
-112-
Bulbs
Bulbs are identified as follows:
[ LP Gas Engine ]
1. Bulb - head lamp halogen (12V - 35W)
*2. Bulb - back up (12V - 8W)
*3. Bulb - turn signal (12V - 23W)
*4. Bulb - stop & tail (12V - 23/8W)
*Optional lamp or light
Fuse & Relay (LP Engine Only)
Circuit Breaker
1. Raise the hood and seat assembly. Make sure the
support cylinder securely holds the hood open.
Typical Example LP Engine Truck
2. The main circuit breaker is located on the rear of the
support for the controls.
NOTE: To reset circuit breakers push in on the button.
The button should stay in if the breaker is reset.
If the button will not stay in, or comes out shortly
after reset, have the circuits checked.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
