Maintenance Section
-134-
2. Lubricate 2 side thrust roller fittings, one on each
side of the mast.
3. Raise the carriage, remove the blocking. Lower the
carriage to the floor.
Carriage Sideshifter (If Equipped) –
Lubricate
1. Lubricate 4 (6) fittings. The forks may have to be
moved to gain access to all of the fittings.
2. Operate the sideshifter carriage through several
complete cycles to distribute the grease the carriage
to the floor.
Parking Brake - Test, Adjust
See topic, “Parking Brake - Test, Adjust” in “First 50-100
Service Hours.”
Circulation Pump Belt (OCDB & LP
Engine Only. If Eguipped) - Check,
Adjust
1. Raise the hood and seat assembly.
2. Check the condition and adjustment of the belt (1).
Correct adjustment allows 10 mm (3/8 inch)
deflection under 45 N of force.
3. To adjust the circulation pump belt, loosen the
mounting bolts (2) and adjust the adjusting inner nut
(3). Tighten the adjusting outer nut (4).
4. Lower the hood and seat assembly.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
