Maintenance Section
-128-
Oil Cooled Disc Brake (OCDB) Type
1. Remove the dip stick/filter cap. Observe the oil level.
2. Maintain the oil level between lower mark and upper
mark on the dip stick/filter cap.
3. Install the dip stick/filter cap.
Mast, Carriage, Lift Chains, &
Attachments - Check, Lubricate
1. Operate the lift, tilt and attachment controls. Listen
for unusual noises. These may indicate a need for
repair.
2. Inspect for loose bolts and nuts on the carriage.
Remove any debris from the carriage and mast.
3. Inspect the forks and attachments for free operation
and damage. Have repairs made if necessary.
4. Brush a film of oil on all links of the chain.
5. Raise and lower the carriage a few times to work
lubricant into the chain links.
NOTICE
Lubricate chains more frequently than normal in
applications where the lift truck is operating in a
atmosphere which could cause corrosion of
components or when lift truck must work in rapid
lift cycles.
6. Inspect the chain anchors and individual links for
wear, loose pins or cracked leaves.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
Need help?
General
