Maintenance Section
-119-
First 50 - 100 Service Hours or a Week
You must read and understand the warnings and instructions contained in the Safety section of this manual, before
performing any operation or maintenance procedures.
Transmission Oil, Oil Filter & Strainer
- Clean, Change
WARNING
Hot oil and components can cause personal injury.
Do not allow hot oil or components to contact skin.
Park the lift truck level, with the forks lowered, parking
brake engaged, transmission in NEUTRAL and the
engine stopped.
1. Remove the drain plug, spring and strainer. Allow
the oil to drain.
NOTICE
Careless disposal of waste oil can harm the
environment and can be dangerous to persons.
Always dispose of waste oil to authorized and licensed
personnel only.
2. Wash the strainer (screen) ,â‘ spring â‘¡ and drain
plug â‘¢ in clean, nonflammable solvent. Dry and
install the strainer, spring and drain plug.
3. Raise the hood and seat assembly.
4. Remove and discard the oil filter. Wipe off the filter
base. Make sure all of the old seal is removed.
5. Put a small amount of clean oil on the seal on the
new filter. Install the filter by hand. When the filter
contacts the base, tighten it an additional 3/4 turn.
6. Close the hood and seat assembly.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
Need help?
General
