Operation Section
-88-
Parking the Lift Truck
Park the lift truck level, with the forks lowered and the
mast tilted forward until the fork tips touch the floor.
Block the drive wheels when parking on an incline.
1. Park in an authorized area only. Do not block traffic.
If LP equipped, do not park near elevator shafts or
any other area where LP could collect in a pocket
(low area), causing a potentially dangerous
condition.
2. Place the transmission controls in NEUTRAL.
3. Engage the parking brake.
4. Lower the forks to the ground.
WARNING
Blocking the wheels will prevent unexpected lift
truck movement, which could cause personal injury.
5. Turn the key in the ignition switch to the OFF
position and remove the key.
NOTE: If a LP equipped lift truck is stopped or parked
for an indefinite or prolonged period of time,
close the fuel shutoff valve on the LP tank. Run
the engine until fuel in the line runs out and the
engine stops. Turn off the ignition switch and
disconnect switch (if equipped).
6. Actuate each loading lever several times to remove
the residual pressure in the respective cylinders and
hoses.
7. Block the drive wheels if parking on an incline.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
