General Section
-39-
Mast Abbreviations
STD - Standard Mast (single inner member, low free lift)
FF - Full Free Lift Mast (single inner member with high
free lift duplex cylinder)
FFT - Triple Lift Mast (two inner members) with either
low or full free lift characteristics.
QUAD - Quadruple (Quad) Mast (with three inner
members)
NOTE : When only a mast-type is listed on the
identification plate, a standard carriage and
forks are used.
Attachment Abbreviations (Includes Special
Forks)
SC - Special Carriage-increased width, height or
outreach
SSS - Shaft-type Sideshift Carriage
HSS - Hook-type Sideshift Carriage (ITA)
CW - Counterweight
SF - Special Forks
SWS - Swing Shift, Sideshift
RAM - Ram or Boom
DBCBH - Double Cube Block Handler
HFP - Hydraulic Fork Positioner
CR - Crane Arm or Crane Boom
TH - Tire Handler
CTH - Container Handler
LPP - Load Push-Pull Device
CC - Carton Clamp
RC - Roll Clamp
LS - Load Stabilizer
PWH - Pulp Wood Handler
SS-ST - Sideshift-Side Tilt Carriage
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
