SP002025
Page 25
Track Excavator Safety
Travel Precautions
Never turn the starting switch to the "O" (OFF) position when
traveling. It is dangerous if the engine stops while the machine is
traveling. It will be impossible to operate the steering.
Attachment control levers should not be operated while
traveling.
Do not change selected travel mode (FAST/SLOW) while
traveling.
Fold in work equipment so the outer end of the boom is as close
to the machine as possible, and is 40 - 50 cm (16 - 20 in)
aboveground.
Never travel over obstacles or slopes that will cause the
machine to tilt severely. Travel around any slope or obstacle that
causes the machine to tilt 10 degrees or more to the right or left,
or 30 degrees or more from front to rear.
Do not operate the steering suddenly. The work equipment may
hit the ground and cause the machine to lose its balance, and
this may damage the machine or structures in the area.
When traveling on rough ground, travel at low speed, and avoid
sudden changes in direction.
Always keep to the permissible water depth. Permissible water
depth is to the centerline of the upper track rollers.
When traveling over bridges or structures on private land, check
first that bridge or structure can withstand the weight of the
machine. When traveling on public roads, check with the local
authorities and follow their instructions.
40 ~ 50 cm (16 ~ 20 in.)
FG000349
INCORRECT
TRAVEL POSTURE
Figure 17
To Next Page
Loading...
