SP002027Fuel Tank
Page 12
INSTALLATION
1. Install two 12 mm eyebolts in threaded holes (38 and 39,
Figure 14). Using a suitable lifting device, sling eyebolts.
2. Set fuel tank (1, Figure 14) into position. Install six bolts (7)
and spacers (13) finger tight, to secure tank to frame.
NOTE: The clear level gauge on the side of the tank is
easily damaged. Be careful of obstacles and
wind gusts.
3. Install shims (9, Figure 14) as needed to prevent tank (1)
from rocking or stress from mounting bolts (7).
4. Tighten mounting bolts (7, Figure 14) after shims are
installed.
NOTE: Bolt torque is 27 kg•m (200 ft lb).
5. Install four bolts (35 and 36, Figure 15) and cover (37) on
fuel tank and support.
6. Connect wires as tagged to fuel sender (16, Figure 16) on
side of fuel tank (1).
9
7
1
39
38
FG003879
13
Figure 14
36
FG003878
37
35
Figure 15
16
1
FG003877
Figure 16
To Next Page
