SP002027
Page 11
Fuel Tank
19. Tag and disconnect wires leading to fuel sender (16,
Figure 11) on side of fuel tank (1).
20. Remove four bolts (35 and 36, Figure 12) and cover (37)
from fuel tank and support.
21. Install two 12 mm eyebolts in threaded holes (38 and 39,
Figure 13). Using a suitable lifting device, sling eyebolts.
22. Remove six bolts (7) and spacers (13, Figure 13) holding
tank (1) to frame. Lift tank 25 mm (1") and make sure it is
balanced. Make sure that there are no other electrical
wires or hoses connected to tank. Completely remove tank
after inspection.
NOTE: The clear level gauge on the side of the tank is
easily damaged. Be careful of obstacles and
wind gusts.
23. Remove shims (9, Figure 13).
NOTE: If tank is to be reused note position and amount
of shims used for each mounting bolt location.
16
1
FG003877
Figure 11
36
FG003878
37
35
Figure 12
9
7
1
39
38
FG003879
13
Figure 13
To Next Page
