Doremi Dimension-3D - System Menu

3.9 System Menu
• The following menu allows access to the system parameters:
Sub-Menu Description
Recall
Load one of the 3 saved presets, the
default settings or factory settings.
Once the desired preset is loaded a “#”
will appear next to the title.
(See Section 3.9.1 )
Save
Save the Current settings as the default
setting on boot or to one of the three
presets.
Once the desired preset is saved a “#”
will appear next to the title.
(See Section 3.9.1 )
Factory Reset? (unit will reboot
automatically).
Firmware: x.y Firmware version
Serial: zzzzzzz Serial number
License: uuuuuuuu License number
Temp: vv C Temperature (in degree Celsius)
Standby Standby mode. Put the unit in Standby
Power Saving mode
Auto Standby Auto Standby mode. Set the idle time
duration before the unit goes in power
down mode automatically:
Off
60 Minutes
120 Minutes
IR Infra-Red. To avoid IR interference when
there are multiple Dimension-3D units,
the user can assign each a different IR
code from 0x0 to 0xF (16 total). The
default IR code is 0. The user needs to
set the DIP switch on the Doremi IR
remote accordingly.
SD memory update SD memory firmware update.
DM3.OM.001026.DRM Page 25 Version 1.4
Doremi Labs Inc.