6.2 SD Memory Card Update
Note: The SD memory card must be formatted to FAT or FAT32.
• To perform an update with an SD memory card, do the following:
• Copy the firmware file (e.g., “DIMENSION_3D_1.8.0.bin”) on the SD Memory Card.
• Plug the SD Memory card into the SD port of the Dimension-3D (Figure 3).
• Power on the Dimension-3D and go to the “System” menu (Section 3.9).
• Select the “SD Memory update” sub-menu.
• Select the file to use for the update using the menu scroll wheel (Figure 2).
• Confirm the update.
• Once the update is complete, turn off the unit and then power it back on.
DM3.OM.001026.DRM Page 46 Version 1.4
Doremi Labs Inc.
To Next Page
Loading...