Dorma PORTEO - Commissioning, Care, and Maintenance; Inspection and Acceptance Test Procedures; Regular Maintenance and Inspection Schedule; Checklist for Tests and Maintenance

DORMA PORTEO
WN 057472 45532 02/08
I
Regular
.
.
( .)
.
.
.
().
,
.
.
.
The has to be switched off and secured against unauthorised or unintended
switching-on before performing maintenance work (cleaning or maintenance)
PORTEO door assistant
Commissioning, care and maintenance (requirements according to DIN 18650-2, 5.1-5.4)
PORTEO door assistant
PORTEO door assistant
Checklist (start-up test, maintenance, regular inspections) for PORTEO door assistant according to
DIN 18650-2, paragraph 5.1-5.4
PORTEO door assistant
only for PORTEO as Full Energy version
DIN 18650 also prescribes safety standards for the commissioning and maintenance of the
complete automatic door system. As long as the facility operator intends to use the
according to this standard, the following requirements prevail
Inspection and acceptance test according to the below-mentioned checklist before the first
commissioning by a person trained by us.
maintenance and inspection, at least 1x a year, under consideration of our
specifications for the by trained staff.
Documentation of the results in accordance with DIN 18650-2 paragraph 5.1-5.4
Safekeeping of the properly filled-out checklist according to our specifications for at least
1 year by the facility operator.
Proper installation according to the instructions of the manufacturer.
Tight fit of the to the lintel/frame respectively, or the door leaf
Check door leaf for smooth running and adjust, if required
Proper functioning of the door (check the opening and closing cycle respectively)
Function of installed activators like radar motion detectors, pushbuttons or remote controls
Function of the contactless safety equipment (safety sensors), if installed
Installation of effective safety equipment to avoid or protect danger spots between certain
parts of the door and between the door and its structural environment, like for example safety
clearances or the protection of the secondary closing edges
Fix inspection plate
Document the inspection and maintenance work
.
Commissioning, care, maintenance
GB 30