23
ED100/ED250 02-2018DL4614-050
dormakaba ED100/ED250 Service Manual Chapter 14
ED/ED Parameter A. standard
Parameter Function Factory setting Adjustment range Para. Requirement
So
Opening speed
automatic
mode
Swing door opening speed,
automatic mode.
°/s
ED °/s - °/s
ED °/s - °/s
..
Swing door opening time to °, not less than
. s.
Sc
Closing speed
automatic
mode
Swing door closing speed,
automatic mode.
°/s
ED °/s - °/s
ED °/s - °/s
..
Swing door closing time to latch check.
Reference Para. ...
Fo
Static force
in opening
direction
Static force on door closing
edge in opening direction.
. lb f
[ N]
. lb f [ N] -
. lb f [ N]
Reduced in low
energy mode.
..
Not to exceed lb f [ N] measured
" [.] from lead edge of door.
Fc
Static force
in closing
direction
Static force on door closing
edge in closing direction.
. lb f
[ N]
. lb f [ N] -
. lb f [ N]
Reduced in low
energy mode
..
Not to exceed lb f [ N] measured
" [.] from lead edge of door at any point in
closing cycle.
bc Back check
Checking or slowing down of
door speed before door being
fully opened.
° ° - ° ..
Shall occur at not less than ° of full open
position.
dd
Hold open
time
Open time for swing doors
using sensors or control mats
upon loss of detection.
s
s - s
s - s
(professional
upgrade card)
.. Minimum of . seconds after loss of detection.
Latch check
Checking or slowing down of
door speed before door being
fully closed.
Not adjustable ..
Not less than ° from closed position.
The door will not close through the final ° in
less than . s.
hS
Support for manual mode in
door closed position.
..
Manual opening force in event of power failure.
Not greater than lb f [ N] applied " [.]
from lead edge to open.
hA
Adjustment, door activation
angle.
hF Power assist function.
14 ANSI/BHMA standards
. A. Power operated pedestrian doors
The following table references portions of content from ANSI/BHMA A.. Refer to the standard, available
through ANSI or BHMA for additional information. Standard material reprinted with BHMA permission.
.. Door measurements, power operated swing door
"D" door width ,
minimum
inches [mm]
"W" door weight,
maximum
pounds [kg]
"T" closing time,
minimum, to latch
check (seconds)
or less [] .
[] [] .
[] [] .
[] [] .
[] [] .
[] [] .
.. A., ..: swing door closing time to latch check .. Other door weights and widths
Closing time T = (D
W
)/
D = Width of door in inches.
W = Weight of door in pounds.
T = Closing time to latch check in seconds.
SI (metric) units
Closing time T = (D
W
)/
D = Width of door in mm.
W = Weight of door in kg.
T = Closing time to latch check in seconds.