Dormakaba ED50 - Page 59

59
ED50/ED100/ED250 09-2021DL4617-003
dormakaba ED50/ED100/ED250 OHC Header
Setup and Troubleshooting Instructions
Appendix A
Parameter
Value
range
Units
Factory
setting
Description
Status relay function, X terminals  Status relay is deactivated.

 -  
 Status relay activated as soon as door reaches door "closed" position.
 Status relay activated as soon as door reaches door "open" position.
 Status relay activated when error codes are displayed on  digit operator display.
 "Door closed and locked" activates status relay.

Status relay activated when information or error codes are displayed on  digit
operator display.

• Status relay activated when door is opened further than opening angle
parameter OA, set during learning cycle.
• Parameter OA value can only be changed using dormakaba handheld or by
performing another learning cycle.
Locking device output configuration;
output X, G (V) and input X, /a
Reference Chapter .

 -  
 Locking device output terminal X, G (V) is independent of Input X, /a.

• Locking device output terminal X, G (V) is turned on as soon as contact at
X, /a is opened..
• Terminal X, G V output is on for as long as contact at X, /a is open,
motor lock with a % duty factor is required.
• This function is not available for DCW motor locks.
Cycle counter
• Total number of opening and closing cycles displayed is shown in increments of
; Display value, "", , cycles, Display value, "", , cycles.
• Total number of cycles can be displayed on dormakaba handheld.
• A display value of "" means , cycles or greater.

 - 
*

cycles
Delete error log

 -  
 No function.

. When "" entered, Error log is deleted.
• Parameter is then automatically reset to "".
Reset service interval display,
operator yellow LED

0 - 1 
 No function.

. When "" entered:
• Service cycle counter is reset to ,.
• Service interval is reset to  months.
• Yellow LED not illuminated.
• Parameter is then automatically reset to "".
• Values other than default values must be set using dormakaba USA, Inc.
handheld:
• Maintenance interval
• Maintenance cycles
A.. Driving parameters detail.