Dormakaba ED50 - Page 61

61
ED50/ED100/ED250 09-2021DL4617-003
dormakaba ED50/ED100/ED250 OHC Header
Setup and Troubleshooting Instructions
Appendix A
Parameter
Value
range
Units
Factory
setting
Description
Power assist function
• Force setting for Power assist function.
• Power assist function only available with hd parameter = , manual mode.
• ""; power assist function OFF. Power assist function enabled for available values
greater than .
• Power assist function enabled when power assist activation angle hA reached.
• The greater the value of hF, the easier the door can be manually opened from power
assist activation angle hA.
• If power assist set too high, door can open automatically.
• Power assist function is not available
• If operator is switched off., A smoke detector or emergency button has been
triggered.

 -  
Additional Power assist function support
from 
• Setting for additional power assist function support from .
• The greater the value of hS, the easier the door can be manually opened from .

 -  
hS
A.. Upgrade card units codes
 -  
 Upgrade card not installed, function not available.
 Upgrade card installed, function not activated.
 Upgrade card installed, function activated.
 Upgrade card has been removed, function no longer available.
Upgrade card fire protection
. Activate function by installing upgrade card, parameter value will automatically
change to  (upgrade card function installed, fire protection function activated).
• Following activation, drive may be used as a electrically controlled hold-open
system according to EN , Building hardware-Electrically controlled hold-
open systems for fire/smoke door assemblies, or similar standards.
• Full energy function (F) is automatically activated (ED/ED).
• Plug for terminal board X socket included with upgrade card.

Available
upgrade card
codes
(Para. A..)
, , 

Full energy– upgrade card not required to
enable function.
ED: low energy only (ANSI/BHMA A.).
• F=, no parameter adjustment.

Available
upgrade card
codes
(Para. A..)
, , 

ED/ED
• F default is , low energy (ANSI/BHMA A.).
. To activate Full energy function (ANSI/BHMA A.) change parameter F to .
• The full setting range of parameters So, Sc, Fo and Fc will be available after the
activation.
• SL (Factory setting level) of  will reset F to .
Not used.


Not used.


Not used.


A.. Driving parameters detail.