Issued July 2024
Body Controller Softw are
Copyright 2024, The Heil Co.
Printed in the U.S.A.
Body Controller Software
121
3.06: Option Config
ON, enables Body Raised warning and indicator circuits. Intended for Dump
Bodies
ON, enables Front Strobe Output
ON, enables Low Torque Pressure Switch Function
ON, allows operator to stow the lift Grabber Open and Lift Retract on the fly.
ON, enables Low Oil Level Detection
ON, prevent operator from opening grabber with lift raised
ON, causes Strobe lights to disengage with Chassis turn signals active
Allow Program Setup, Chooses Body Type
Changes controller J1939 Baud Rate 250k/500k
ON, Enables Hydraulic Oil Temp Sensor
ON, Enables Out of Dimension. Output. Default setpoint 7 mph w/1-12 mph
range. Default function includes Lift and Body components w/option for Lift
only.
Press OK to set maximum MPH for Lift Operation. Default setpoint 7 mph w/1-
12 mph range.
Press OK to set maximum MPH for Hyd. Pump/PTO Operation. Default
setpoint 25 mph w/1-45 mph range.
ON, Enables Front Strobe Output
To Next Page
Loading...