Issued July 2024
Body Controller Softw are
Copyright 2024, The Heil Co.
Printed in the U.S.A.
Body Controller Software
122
ON, Enables Low Torque Pressure Switch Function
ON, Allow operator to stow the lift Grabber Open and Lift Retract on the fly.
ON, Enables Low Oil Level Detection
ON, Causes Strobe lights to disengage with Chassis turn signals active
Allow Program Setup, Chooses Body Type
Changes controller J1939 Baud Rate 250k/500k
ON, Enables Hydraulic Oil Temp Sensor
Press OK to set maximum MPH for Lift Operation. Default setpoint 7 mph w/1-
12 mph range.
Press OK to set maximum MPH for Hyd. Pump/PTO Operation. Default
setpoint 25 mph w/1-45 mph range.
ON, enables Body Raised warning and indicator circuits. Intended for Dump
Bodies
ON, Enables Front Strobe Output
ON, Enables Low Torque Pressure Switch Function
ON, prevent operator from opening grabber with lift raised with Joystick
Button
ON, prevent operator from opening grabber with lift raised
ON, Enables Low Oil Level Detection
ON, Causes Strobe lights to disengage with Chassis turn signals active
To Next Page
Loading...