Troubleshooting
A70622-D1
156/192
SPS Upgrade From safety level PLc to PLd 2 / 2
Note
,4 in the I/O window are
automatically initiated and set to their specific
UI will force the In 1 label to “External Interlock 2”.
UI will force the In 2 label to “Source safety loop”.
UI will force the In 3 label to “Shutter safety loop”.
force the In 4 label to “Non usable”.
SPS Replacing LED Indicator 1 / 1
Special Tools
Allen Key 2mm + Allen key 5mm
Prerequisite
Switch off the laser / Unplug from the mains supply
Remarks
-
1
Remove the cover by unscrewing the CHC screws.
Remove the cover carefully because the wires of the LED are very short.
Replace the LED indicator.
To Next Page
Loading...