Dräger EM200-E - 3.3 Check Function of the MSI EM200-E; 3.4 Terminating Measurement

Instruction Manual Dräger MSI EM200-E
6
3.3 Check Function of the MSI EM200-E
Electronic, measuring system and all sensors are tested.
If all checks have proved to be error free, then the display will read:
With "F" ( OK ) you affirm the result and call the menu "Selection of Functions" (see 4.).
If errors have been detected, error messages (see 12.) will be generated and displayed.
After pushing "F" ( CONTINUE ) the menu "Selection of Functions" (see 4.) is shown.
3.4 Terminating Measurement
After the measurement remove the probe from the exhaust gas and allow fresh ambient air
to be sucked in for 1 to 2 minutes.
After this, switch off the instrument by using the switch off function in the menu "Selection of
Functions" (see 4.) or by pushing "F" until the display reads "Switch off" (approx. > 3 sec).
Empty and clean the gas conditioner. Check the filter fleece and the filter disks and re-
place them if they are visibly dirty. For pushing out the filter disks use a small screw driver
or a paper clip.
Gas conditioner:
Top Bottom
screw driver filter disk condensate outlet filter fleece filter disk