Dräger MIcroVent - Pneumatic Connections

1 Attach flow sensor to wye.
2 Push elbow connector onto flow sensor.
When using a bacterial filter
● Always connect bacterial filter to elbow connector as
shown.
● Push pressure sensing lines for flow measurement
onto flow sensor nipples – note different diameters of
hose ends and respective nipples.
Pneumatic Connections
1
Attach gas supply line and tighten.
2 Attach pressure sensing lines for flow measurement
to connector on MicroVent.
CAUTION !
Do not pressurize this connector for pressure
sensing lines. It might destroy the internal sensor.
CAUTION !
Always use elbow connector for accurate flow
measurement
Preparation Assembly
16
Operating Instructions MicroVent
12
4
3