Physical Characteristics
Dimensions
(W x H x D) 215 x 120 x 205 mm
(8,5 x 4,7 x 8,1 inches)
Weight 4.3 kg (9.5 lbs)
Noise level during
operation 48 dB(A) in 1 m distance
Construction materials
Ventilator enclosure Impact resistant ABS plastic
Reusable patient circuit silicone rubber
pressure sensing lines
for flow measurement silicone rubber
flow sensor housing polysulphone (PSU)
flow sensor membrane stainless steel
Expiration valve housing polysulphone (PSU)
Expiration valve membrane silicone rubber
ventilator front panel
key pad polyester membrane
Certificates
The MicroVent ventilator has been tested for electromag-
netic compatibility according to the following standards
and guidelines:
Electromagnetic IEC 601-1-2
emissions and prEN 794-1
immunity MIL-STD-461D/462
RE 101 / RS 101 / CS 101
Vibration and shock test MIL-STD-810E
Electrical supply
Electrical power input
into MicroVent 12 V ±1 V DC
Connection to external
supplies 12/24/28 V DC via DC/DC converter
(84 13 017)
Fuse T1L 250V IEC 127-2
(behind lid of battery
compartment)
Connection to external via AC adapter (84 12 709)
AC source input: 120V/60Hz AC
max. 200 mA
output: 12 V DC
max. 600 mA
Current consumption
during rapid charge
ventilator off 300 mA (for 8 hours, after
that automatic switch to
trickle charge)
ventilator on 390 mA
during trickle charge 30 mA
Ambient temperature
range during charge
of NiCd 32 to 95 ºF (0 to 35 ºC)
Time of operation with max. 2 hours at 41 to 122 ºF
internal NiCd or alkaline (5 to 50 ºC)
battery pack with typical settings
Insulation class of
power supply II
Q
pursuant IEC 601
Classification type BF
Technical Data Operating Data
58
Operating Instructions MicroVent
m
To Next Page
Loading...
