Dräger Narkomed 2B - General

Section 7
Specifications
General
Dimensions (approximate) (WxHxD) ....... 32x601/2x27inches
Weight (approximate) ................................ 400lbs
Environmental
Storage
Temperature ...................................... -20–60°C
Humidity ............... 10–90% relative humidity (noncondensing)
Operating
Temperature ...................................... 10–40°C
Humidity ............... 30–75% relative humidity (noncondensing)
Electrical
Equipment class ....................... IEC601Class 1, Type B
Leakage current ............................. ≤ 100 microamps
Ground impedance ......................≤ 0.1 ohm (60 Hz source)
Dielectric withstand ................... ≥ 1500 VAC (per UL 544)
Chassis resistance (between any metallic point
and ground pin on power cord) ..................... ≤ 0.1 ohm
117 Volt Power
Supply
Primary input voltage (acceptable range) .............. 90–130 VAC
@ 50/60 Hz
Primary input current ..................... ≤ 6 amps (RMS total)
≤ 1 amps (machine)
≤ 5 amps (receptacles)
Primary input power (includes receptacles) .............≤ 780 Watts
220/240 Volt
Power Supply
Primary input voltage (acceptable range) ............. 200–260 VAC
@ 50/60 Hz
Primary input current .............................. ≤ 0.4 amp
@ 240 VAC, 50 Hz
Primary input power ..............................≤ 104 Watts
Backup Battery
Type ........................ Sealed lead-acid, maintenance-free
Charging time ....................................≤ 16 hours
Reserve power time (from full charge) ................... ≥ 30 min
Circuit Breakers
Primary AC power input (machine) 1.0 amp AC (117 VAC power supply)
0.5 amp AC (240 VAC power supply)
Convenience receptacles (117 VAC power supply only) .... 5.0ampsAC
Reserve battery power ............................ 4.0ampsDC
Miscellaneous
Conductive caster resistance ....................... ≤ 250 kohms
7-1