Section 5 - Operation
Monitoring System
When you are ready to resume operation, press the
key indicated on the left-hand screen.
NONFUNCTIONAL A serious fault was detected. The monitoring
system will not operate under this condition. Do not
use the machine. Immediately notify a North
American Dräger qualified technical service
representative to correct the problem.
Monitor Screens
and Controls
Following a successful power-up, monitoring information is displayed on
the anesthesia machine’s screens. The keys to the right of each screen
allow you to control the displays and other monitor functions.
Left-Hand Screen
The top half of the left-hand screen displays alarm messages. (These
alarms were discussed in detail in Chapter 2.) On the bottom half of the
screen, you can display graphical trace or trend data. You can also use
this area of the screen to configure the anesthesia machine.
The four keys to the right of the screen control the audio annunciation of
alarms and the type of data displayed on the screen. These keys are
discussed in this section.
TRACE AND TREND
DISPLAY AREA
CENTRAL ALARM
DISPLAY
SYSTEM
CONTROLS
WARNING CAUTION ADVISORY
% OXYGEN LOW O2/N2O LOW THRESHOLD LOW
TRACE
OP20015
TREND
5-9-2
To Next Page
Loading...
