Section 5 - Operation
Monitoring System
Configuring the
Anesthesia Machine
You can configure the following parameters on the Narkomed 2B:
– audio annunciator volume
– current date
– current time
– serial Port A parameters
NOTE: You can configure Port A only. It communicates
using the Vitalink Communications Protocol. (Refer
to the Vitalink Technical Reference Manual for
Vitalink programming details.) You cannot
configure Port B. It is permanently configured for
use with the Co•Writer anesthesia recorder.
When you start the anesthesia machine, it uses the values that were
established the last time the machine was configured. You can view or
change these values on the Configure screen.
Displaying the
Configure Screen
To display the Configure screen, press the CONFIG key. The CONFIG
key is located in the bottom row of keys to the right of the right-hand
display screen. (See the figure on the previous page.)
The Configure screen replaces the standard left-hand screen display of
alarms, trends, and waveforms. You must begin configuration within one
minute, or the standard screen will replace the Configure screen.
TREND
TRACE
OP20020
CONFIGURE SCREEN
AUDIO VOLUME
DATE
TIME
SELECT
INC
DEC
EXIT
2
JUL
11:50
PORT A CONFIGURATION
BAUD RATE
PARITY
STOP BITS
DATA BITS
PROTOCOL
1200
NONE
1
8
VITALINK 1
5-9-4
To Next Page
Loading...
