Need help?Do you have a question about the Dräger Narkomed 2C and is the answer not in the manual?
General| Manufacturer | Dräger |
|---|---|
| Model | Narkomed 2C |
| Oxygen Flush | Yes |
| Ventilator Type | Pneumatically driven, electronically controlled |
| Ventilation Modes | Volume Control, Pressure Control |
| Gas Inlets | Oxygen, Air, Nitrous Oxide |
| Integrated Vaporizers | Accommodates up to two vaporizers |
| Monitoring Parameters | Oxygen concentration, airway pressure, respiratory rate, tidal volume, minute volume, anesthetic agent concentration |
| Alarms | High and low airway pressure, high and low oxygen concentration, apnea |
| Monitor | Integrated monitor displays ventilation parameters, gas concentrations, and alarm settings |
| Vaporizers | Isoflurane, Sevoflurane |
Explains the manual's structure and how to use its sections.
Provides general advice for troubleshooting the Narkomed 2C system.
Displays machine serial number, service dates, and hours run. Accesses other service screens.
Displays a log of service events with date, time, parameter, code, and description.
Displays O2 cell readings, zero calibration, and stored calibration values.
Displays airway pressure, zero/span calibration, and stored calibration values.
Outlines voltage distribution scheme and test points within the machine.
Lists failure modes and symptoms keyed to flow charts for problem diagnosis.
Troubleshooting flowchart for issues related to the O2 monitor.
Troubleshooting flowchart for display blank issues upon system power-up.
Provides instructions for replacing cylinder yoke assemblies.
Details procedures for replacing cylinder pressure regulators.
Procedures for replacing the oxygen supply failure protection device (failsafe assembly).
Procedures for replacing the alarm channel assembly and the O2 supply pressure alarm switch.
Procedures for removing and installing vaporizers, including draining and drying.
Procedure for adjusting cylinder pressure regulators, excluding CO2.
Procedure for adjusting the O2 supply pressure alarm switch.
Procedure for adjusting the Oxygen Ratio Controller (ORC).
Procedure for zero and 21% calibration of the oxygen sensor.
Procedure for zero and span calibration of the breathing pressure monitor.
General instructions for performing PMC inspections on Narkomed anesthesia machines.
Procedures for verifying ground continuity and circuit isolation.
Verifies system status via self-diagnostics and records software version.
Performs zero and span calibrations for Oxygen Monitor and Breathing Pressure Monitor.
Inspection of absorber system components like valve domes and canisters.
Tests for leaks in the fresh gas system.
Procedures for installing NM2C software from a PC.
Procedures for installing NM2C software from an ORDM.
Procedures for installing NM2C software using the SST from a PC.
Overview of SST operations and main menu functions.
Lists parts for processor assembly and related components.
Lists parts for the AV-2 Ventilator Controller Assembly.
Lists parts for the Bellows Valve Assembly.
Lists flow tubes, restrictor assemblies, and flow control valves.
Lists parts for the O2 Regulator Assembly.
Lists yoke assemblies, common parts, and gas identification labels.
Lists parts for O2 sensor interface panel assembly.
Lists filter, cord assembly, caster, power supply, battery, circuit breakers.
Lists parts for the absorber assembly, including valve assemblies.
Lists parts for the ultrasonic flow sensor assembly.
To Next Page