Dräger Narkomed 2C - Main Service Screen

DIAGNOSTICS (continued) NM2C
2.1 Main Service Screen
2.1.1 View Mode
The Main Service Screen displays the machine serial number, the last service
date, hours run since last service and total hours run. Selections listed on the
right side of the display allow entry into additional service screens.
To access the Main Service Screen, press and hold the and
VENTILATION
ALARMS OFF
keys, and press the Datagrip trigger. The View Mode service screen shown in
Figure 2-2 will then appear. (The VENTILATION ALARMS OFF key was
labeled LOG DATA on earlier machines.)
If the MONITORS service screens are accessed in the view mode, current
values will be displayed but the operator will not be able to perform
calibrations.
Additionalservice modescreens are describedin thenext paragraph. Theseare
accessed by pressing the trigger, which will highlight VIEW. Then scroll to the
desired service mode with the selection wheel and press the trigger.
MAIN SERVICE SCREEN
MACHINE SERIAL NUMBER : XXXXXXXX
LAST SERVICE DATE : 1- 3-94
HOURS RUN SINCE LAST SERVICE : 97
TOTAL HOURS RUN : 3383
VIEW
SERVICE CODE
EXIT
PMS
CRITERIA
MONITORS
SERVICE
LOG
MAIN
SELECTS
FUNCTION
⇒ TO ADJUST
SETTING
NVRAM
DUMP
Figure 2-2: MAIN SERVICE SCREEN, VIEW MODE
Rev. A
2-2
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS