NM2C ADJUSTMENT AND CALIBRATION PROCEDURES
5.0 ADJUSTMENT AND CALIBRATION PROCEDURES
Equipment Required:
-- Test Gauge for setting cylinder pressure regulators,
NAD Part No. S000063A
-- Oxygen Monitor for adjusting Oxygen Ratio Controller
-- Test fixture with breathing pressure line connector, TEE connector,
gauge, and inflation device, for breathing pressure monitor calibration
-- 7/64 in. hex wrench for display arm friction adjustment.
Rev. B
5-1
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
To Next Page
Loading...
