Dräger PEX 3000

Menu structure
Page 12 of 42
9023810 - 2nd edition - September 2005
Normal operation (Measuring Mode)
displaying values between 0 and 99 resp. 0 and 9.9
Signal output 4 to 20 mA
If there is no key activated within 4 minutes in an arbitrary state the transmitter will automatically switch-over to the normal
operation without saving any data.
SL
Test output 4-20 mA
Fault
Display shows E0 to E8
Signal output 1 mA
if the detected
fault is removed
if a fault
is detected
long
(>3 s)
short (>1 s and <3 s)
CL
Calibration 4-20 mA
CU
Adjust sensor current
dP
Set Decimal point
So
Software-Version
Keys
q+l
Keys
q+l
Tasten
q+l
Keys
q+l
Keys
q+l
Signal output
4.0 mA
Signal output
4.0 mA
Signal output
3.4 mA
Signal output
3.4 mA
Signal output
3.4 mA
Set signal output
to X mA
see page 14
Adjustment
signal output
see page 14
Adjustment of
sensor current
see page 15
Switch-on/off
decimal point
see page 15
Display
software version
see page 15
Maintenance Menu
ZE
Calibration
Zero Point
SP
Calibration
Span
Keys
q+l
Key
lM
Keys
q+l
Signal output
3.4 mA
Signal output
3.4 mA
Adjustment of
zero point
see page 13
Adjustment of
span
see page 13
Calibration Menu
q
q
q
q
q
l
q
l
q
l
l
l
02223810_1_en.eps