Dräger Polytron 8000

Settings menu
Dräger Polytron 8000 25
Information about measurement units
The Polytron 8000 represents the measured value in various
optional units. The following are available:
The Polytron 8000 automatically calculates the correct value.
Information about the 20 mA measuring range
The maximum range can be set with this function. At the
maximum range set, the device outputs 20 mA on the 4-20 mA
interface.
8.4.6 Resetting the sensor to factory settings
This function resets all the sensor parameters to the factory
default settings (see chapter 12.3 on page 32).
1. Select Settings > Sensor > Sensor reset and confirm.
2. Select Confirm and confirm.
8.4.7 Setting the calibration interval
1. Select Settings > Sensor > Calibration interval and
confirm.
2. Set the calibration interval and confirm.
z ppb z kPa z ubar
z ppm z L/m
3
z ug/L
z vol. % z mbar z ug/m
3
z %LEL z mg/L z uL/L
z %LIE z mg/m
3
z uL/m
3
z %UEG z mL/L z Pa
z hPa z mL/m
3
NOTICE
The calibration interval can be set between 0 and
720 days.
i
i