5327.400 Vapor 2000 5/99 General Page 5
For internal use only. Copyright reserved.
GBK5327400A01.fm 19.01.00
1 Symbols and Definitions
− A dash (−) is used to identify items on a list.
− A bullet (•) is used to identify a sentence that contains direct work instructions.
This symbol is used to provide important information that, if ignored, could
lead directly to a patient’s or operator’s injury. It is also used to provide
important information that, if ignored, could lead directly to equipment
damage and, indirectly, to a patient’s injury.
This symbol is used to provide additional information, operating tips, or
maintenance suggestions.
Definitions according to German standard DIN 31051:
Inspection = examination of actual condition
Servicing = measures to maintain specified condition
Repair = measures to restore specified condition
Maintenance = inspection, servicing, and repair
To Next Page
Loading...
