Need help?Do you have a question about the Dräger Vista 120 and is the answer not in the manual?
General| Manufacturer | Dräger |
|---|---|
| Model | Vista 120 |
| Data Transmission | Wired and wireless |
| Wireless Communication | Wi-Fi |
| Connectivity | Ethernet, USB |
| Compatibility | Dräger medical devices |
| Protocols Supported | HL7 |
| Power Supply | AC 100-240V, 50/60Hz |
| Operating Temperature | 10°C to 40°C |
| Type | Medical Device Gateway |
Steps for installation involve running setup.exe, installing base items, and proceeding through the wizard.
Uninstall Gateway via Control Panel > Programs > Uninstall Vista 120 Gateway.
Access McAfee Firewall settings to configure Gateway's internet connection.
Set Gateway's firewall rule to 'Open to all devices' for network communication.
Log in using Config Tool to access software authorization and configurations after installation.
Change the login password for security after initial login via the 'Change Password' option.
Reset the password by entering the initial and new passwords and confirming the action.
Set up network parameters for HIS and Gateway, including IP addresses and listening ports.
Restart the Gateway to apply network configuration changes and refresh device list.
To Next Page