Dräger Vista 120

To Next Page

To Previous Page

Introduction

8 Vista 120 Gateway User Manual

Introduction

Intended Use

Vista 120 Gateway (hereafter called “Gateway”) is intended to receive physiological data collected by

patient monitors (hereafter called “monitors”), send the data to external systems (e.g. HIS) after the data

are converted to HL7 messages, and transmit the control information sent by external systems to

monitors.

Scope of Application

Gateway is applied to load ECG, RESP, NIBP, SpO2, PR, TEMP, IBP, CO, CO2, AG, BIS, VENT, and AM

data collected by the manufacturer’s monitors (e.g. Vista120, Vista120 S) to external systems in hospital.

NOTE

Please read this chapter carefully before you use the software and ask professionals authorized by the

manufacturer to connect and install Gateway.

NOTE

All the descriptions or pictures in this manual are based on Windows Server 2016 Standard 64 bit

system. Operation descriptions or pictures in other systems may differ from that in Windows Server 2016

Standard 64 bit.

NOTE

While a monitor measures real-time NIBP and at the same time, Gateway sends a periodic R01

message to external systems, the periodic R01 message sent by Gateway at the time does not have

NIBP data.