Vigor2912 Series User’s Guide
95
Load Balance: Check this box to enable auto load balance
function for such WAN interface.
When the data traffic is large, the WAN interface with the
function enabled will balance the data transmission
automatically among all of the WAN interfaces in
connection status.
After finished the above settings, click OK to save the settings.
4
4
.
.
1
1
.
.
3
3
I
I
n
n
t
t
e
e
r
r
n
n
e
e
t
t
A
A
c
c
c
c
e
e
s
s
s
s
For the router supports multi-WAN function, the users can set different WAN settings (for
WAN1/WAN2/WAN3) for Internet Access. Due to different Physical Mode for WAN
interface, the Access Mode for these connections also varies. Refer to the following figures.
Available settings are explained as follows:
Item Description
Index
Display the WAN interface.
Display Name
It shows the name of the WAN1/WAN2/WAN3 that
entered in general setup.
Physical Mode
It shows the physical connection for WAN1/WAN2
(Ethernet) /WAN3 (USB) according to the real network
connection.
Access Mode
Use the drop down list to choose a proper access mode.
Then, click Details Page for accessing the settings page to
configure the settings.
To Next Page
Loading...
Need help?
General
