Vigor2912 Series User’s Guide
122
Click Index 1 to access into the following page for configuring load-balance policy.
Available settings are explained as follows:
Item Description
Enable
Check this box to enable this policy.
Protocol
Use the drop-down menu to choose a proper protocol for
the WAN interface.
Binding WAN interface
Choose the WAN interface (WAN1/WAN2/WAN3) for
binding.
Auto failover to other WAN – Check this button to lead
the data passing through other WAN automatically when
the selected WAN interface is failover.
Src IP Start
Type the source IP start for the specified WAN interface.
Src IP End
Type the source IP end for the specified WAN interface. If
this field is blank, it means that all the source IPs inside the
LAN will be passed through the WAN interface.
Dest IP Start
Type the destination IP start for the specified WAN
interface.
Dest IP End
Type the destination IP end for the specified WAN
interface. If this field is blank, it means that all the
destination IPs will be passed through the WAN interface.
Dest Port Start
Type the destination port start for the destination IP.
To Next Page
Loading...
Need help?
General
