Vigor2950 Series User’s Guide
96
Profile Name Specify a name for the profile of the LAN-to-LAN
connection.
Enable this profile Check here to activate this profile.
VPN Connection Through Use the drop down menu to choose a proper WAN interface
for this profile. This setting is useful for dial-out only.
WAN1 First - While connecting, the router will use WAN1
as the first channel for VPN connection. If WAN1 fails, the
router will use another WAN interface instead.
WAN1 Only - While connecting, the router will use WAN1
as the only channel for VPN connection.
WAN2 First - While connecting, the router will use WAN2
as the first channel for VPN connection. If WAN2 fails, the
router will use another WAN interface instead.
WAN2 Only - While connecting, the router will use WAN2
as the only channel for VPN connection.
Netbios Naming Packet Pass – click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel while
connecting.
Block – When there is conflict occurred between the hosts on
both sides of VPN Tunnel in connecting, such function can
block data transmission of Netbios Naming Packet inside the
tunnel.