Vigor2950 Series User’s Guide
128
Suppose that you could assign the MSN number 123 to the client “alan”.
Type the specified MSN number in the CAPI-based software. When the Virtual TA server
sends an alert signal to the specified Virtual TA client, the CAPI-based software will also
receive the action, the software will not accept the incoming call.
3
3
.
.
1
1
0
0
.
.
5
5
C
C
a
a
l
l
l
l
C
C
o
o
n
n
t
t
r
r
o
o
l
l
Some applications require that the router (only for the ISDN models) be remotely activated,
or be able to dial up to the ISP via the ISDN interface. Vigor routers provide this feature by
allowing user to make a phone call to the router and then ask it to dial up to the ISP.
Accordingly, a teleworker can access the remote network to retrieve resources. Of course, a
fixed IP address is required for WAN connection and some internal network resource has to
be exposed for remote users, such as FTP, WWW.
Call Control Setup Dial Retry - It specifies the dial retry counts per triggered
packet. A triggered packet is the packet whose destination is
outside the local network. The default setting is no dial retry.
If set to 5, for each triggered packet, the router will dial 5
times until it is connected to the ISP or remote access router.
Dial Delay Interval - It specifies the interval between dialup
retries. By default, the interval is 0 second.
Remote Activation – It can help users who would like to
access the server which is off the Internet in the head office.
To remotely make the server to be available on the Internet, i.e.
make the router in the head office activating its Internet access
either by dialing-up or starting broadband connection, users
can make a regular phone call (the number is set in the
Remote Activation field) to the router as signaling it for
activation. The phone call will be soon disconnected once the
router is on line.
To Next Page
Loading...
Need help?
General
