Vigor2950 Series User’s Guide
20
Below shows the menu items for Internet Access.
3
3
.
.
1
1
.
.
2
2
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
This section will introduce some general settings of Internet and explain the connection
modes for WAN1 and WAN2 in details.
This router supports dual WAN function. It allows users to access Internet and combine the
bandwidth of the dual WAN to speed up the transmission through the network. Each WAN
port can connect to different ISPs, Even if the ISPs use different technology to provide
telecommunication service (such as DSL, Cable modem, etc.). If any connection problem
occurred on one of the ISP connections, all the traffic will be guided and switched to the
normal communication port for proper operation. Please configure WAN1 and WAN2
settings.
This webpage allows you to set general setup for WAN1 and WAN respectively.
Note: In default, WAN1 and WAN2 are enabled.
Enable Choose Yes to invoke the settings for this WAN interface.
Choose No to disable the settings for this WAN interface.
Display Name Type the description for the WAN1/WAN2 interface.
Physical Mode For WAN1, the physical connection is done through ADSL
port; yet the physical connection for WAN2 is done through
an Ethernet port (P1). You cannot change it.
To Next Page
Loading...
Need help?
General
