36 of 36
User Manual - ProVideo GUI v1.2.4
where the update files are placed and click “Open”. You do not have to select the
file directly, the GUI will automatically choose the correct update file and display its
name in the “Filename” field. An Update can consist of more then one file, in that
case the total amount of files is shown to the left of the progress bar.
Alternatively you can also drag an update file from your file explorer and drop it
anywhere on the Update Tab to load it.
8 Shows information about the file which is currently being flashed to the device.
9 If you wish you can run an additional verification check after the update was
performed. Usually this is not needed, as the update process is safe.
10 Click the “Start” button to initiate the update process. The progress bar will inform
you about the current status.
Note: During the update the “Start” button will change into the “Abort” button. Click it to
stop the update. Please note that aborting the update will leave your device in a non-
functional state, you have to re-run the update to make the device operational again. If
you do not finish the update you might not be able to access the device with the GUI and
have to flash it using an update script.
Note: For ATOM one SSM500 camera models update via the GUI is not possible, please
refer to the Reference Manual of these devices, on how to perform a firmware update.
To Previous Page
Loading...
