DSE DSE892 SNMP - ETHERNET (SINGLE CONTROLLER); ETHERNET (MULTIPLE CONTROLLER); TYPICAL CONNECTION TO SNMP MANAGEMENT SYSTEM

Installation
18
3.15.7 ETHERNET (SINGLE CONTROLLER)
Ethernet connection utilises a standard Ethernet cable with RJ45 connectors. You must use a
multiport network router as the DSE892 requires an Ethernet connection to communicate with the
SNMP manager.
3.15.8 ETHERNET (MULTIPLE CONTROLLER)
Ethernet connection utilises a standard Ethernet cable with RJ45 connectors.
3.16 TYPICAL CONNECTION TO SNMP MANAGEMENT SYSTEM
The DSE892 gateway communicates with third party SNMP systems confirming to SNMPv1
specification.
This connection is via Ethernet (or internet).
Internet or Ethernet
switch/router
Internet or Ethernet
switch/router