DSE DSE892 SNMP - E-MAIL

Setup
26
6.2.3 E-MAIL
DSE892 is capable of sending an email to one or two addresses upon detection of an event in the
managed devices.
Ensure you consult with the IT/Network manager of the site that the DSE892 is connected to before
making any changes to these settings.
Parameter
Description
Recipient A
Recipient B
Name and email address of the recipients.
Where only one email is required, leave Name and Email blank for one
recipient.
Sender The Name and Email address that the email will appear to have been sent
from.
Server Network address of the SMTP server used to send emails.
Port Which network TCP port is used to send SMTP emails.
Typically port 587 is used for SMTP. Some legacy systems may still be
configured to 25.
Domain The network Domain Name where the DSE892 is part of a Domain system.
Require
authentication
 = The SMTP server requires a username and password for access.
 = The SMTP server does not require authentication.
Username
Password
Username and Password for the SMTP server (when required).
Send Test Click to send a test email to the configured recipients.