Setup
33
6.3.1 MODULE PAGE
Each connection configured on the Modbus Passthrough page has it’s own configuration page as
detailed below. The Name of the connection is used to give a meaningful name to the Module
Configuration Page.
6.3.1.1 MONITORING EVENTS
Event For details of supported Events in your connected controller you are referred to
the relevant DSE Configuration Suite PC Software Manual.
SNMP Trap = This event will not generate an SNMP trap.
= Where supported by the connected controller’s event log, the Gateway
generates an SNMP TRAP message upon activation of this event.
E-Mail Add 1
E-Mail Add 2
= This event will not be sent to the email address.
= Where supported by the connected controller’s event log, the Gateway
sends an email to the specified address(es) upon activation of this event.
To Next Page
Loading...
