Clutch lever
Pull lever (1) towards the handgrip to activate the
clutch.
The system is hydraulically operated and you just
need to pull the lever gently.
The brake lever has a dial adjuster (2) for adjusting
the distance between lever and twistgrip on the
handlebar.
The lever distance can be adjusted through 10 clicks
of the dial (2).
Turn clockwise to increase lever distance from the
handgrip. Turn the adjuster anticlockwise to
decrease lever distance.
Using the clutch properly will avoid damage to
transmission and spare the engine.
Set clutch lever when motorcycle is stopped.
Before using these controls, thoroughly read
instructions under paragraph "Moving
Note
The engine can be with the side stand
down and the gearbox in neutral. If with a
gear engaged, pull in the clutch lever (in this case the
side stand must be up before engaging the gear).
Fig 80
105
To Next Page
Loading...
Need help?
General
