Light control
Low / High beam
At Key-On, the high beam and low beam lights are
OFF: only the parking lights are turned on.
When the engine is the low beam is
automatically switched on. It is possible to switch
from low to high beam and vice versa with
(7),positions (B) and (A), or flash with (3). If
engine is not upon key-on, it is anyway
possible to switch low/high beams on by pushing
(7), positions (B) and (A), or flash with
(3) on LH switch.
If within 60 seconds from the manual switching on of
the low / high beam the engine is not the
lights are disabled again
To preserve the motorcycle if when
the engine the high/low beams are on, the headlight
is automatically switched and then on again
when the engine is
Fig 71
95
To Next Page
Loading...
Need help?
General
