DQS - accessory
DQS function is an option.
If DQS is installed on the motorcycle, the instrument
panel displays DQS status as follows:
●
if DQS system is enabled, the indication to
engage the gears "DQS – UP/DW" is displayed;
●
if DQS system is in reduced mode,
the indication to engage the gears "DQS –
UP/DW" is displayed flashing;
●
if DQS system is disabled, "DQS –" is displayed;
●
if the DQS system or the control unit is in fault,
the “DQS –” indication is displayed flashing.
The DQS with up/down feature allows the rider to
and without using the clutch lever.
It includes a two-way microswitch - built in the lever
mechanism - that outputs a signal to the engine
control unit whenever the is operated.
The system works in a way when
and
Here below are some tips that will ensure you
properly exploit this feature:
1) The Ducati Quick takes the same lever
operation as with vehicle not equipped with the
Ducati Quick Ducati Quick is not
designed for automatically.
2) For any request (up or down) the rider
has to move the lever from its idle position
in the desired direction against the force of the
spring through a over-travel, then keep
the lever in this position until the
is completed. Once the has been
completed, the lever has to be fully released in
order to allow another acted by Ducati
Quick If the rider does not move the
Fig 107
154
To Next Page
Loading...
Need help?
General
