ABS enabling/disabling
This Function allows disabling or enabling the ABS
system without entering the Menu.
Note
“Manual” disabling and enabling of the ABS is
only possible in ENDURO Riding Mode.
If the ABS is enabled, the instrument panel shows
“ABS-ON”.
Once "ABS-ON" is displayed, press (4) to
disable the ABS.
Note
Vehicle speed must be below or equal to 5 km/
h (3 mph) for activating the ABS disabling procedure;
if it is not so, you can only scroll the functions of the
Menu using (1) and (2).
When pressing (4) within the Menu, “WAIT …”
is displayed for 2 seconds. During this time, Menu
scrolling via (1) and (2) is disabled.
When system is disabled, “ABS OFF” is displayed,
the ABS warning light turns on to indicate that the
ABS is disabled and (1) and (2) are enabled.
If the ABS is disabled, the instrument panel shows
“ABS-OFF” and ABS light on. Once "ABS-OFF" is
displayed, press (4) to enable the ABS.
Note
Vehicle speed must be below or equal to 5 km/
h (3 mph) for activating the ABS enabling procedure;
if it is not so, you can only scroll the functions of the
Menu using (1) and (2).
When pressing (4) within the Menu, “WAIT …”
is displayed for 2 seconds. During this time, Menu
scrolling via (1) and (2) is disabled.
Fig 111
161
To Next Page
Loading...
Need help?
General
