The side stand must be fully up (in a horizontal
position) as its safety sensor prevents engine
when down.
Note
It is possible to the engine with side stand
down and the gearbox in neutral. When the
motorcycle with a gear engaged, pull the clutch lever
(in this case the side stand must be up).
Make sure that emergency switch (3), is
set to (B)
.
Move the switch (3) to the (C) and release
it.
Let the motorcycle without operating the
control.
Note
If the is flat, system automatically
inhibits motor cranking operation.
Do not rev up the engine when it is cold. Allow
some time for oil to be heated and reach all points
that need lubricating.
Keeping the engine running for too long with
the vehicle stationary may cause damage due to
overheating caused by cooling. Do not
run the engine unnecessarily while the vehicle is
stationary. Move immediately the
engine.
Fig 92
116
To Next Page
Loading...
Need help?
General
