the
Grease the screws (3).
Fit the on its mount, connect the positive
cable (4) and ABS positive cable (5) to the positive
terminal, and the negative cable (6) to the negative
terminal of the always from the
positive one (+), and the screws (3).
Fit the mounting bracket (2) and tighten the
screw (1).
The gives explosive gases; never
cause sparks or allow naked flames and
near the When charging the ensure
that the working area is properly ventilated.
Charge the in a ventilated room.
Connect the charger leads to the
terminals: the red one to the positive terminal (+),
the black one to the negative terminal (-).
Ducati disclaims any liability deriving from the use of
non-original Ducati chargers or maintainers.
It is recommended to use the Ducati dedicated
charge maintainer Maintenance Kit
no. 69928471A (Europe), no. 69928471AW
(Japan), 69928471AX (Australia), 69928471AY (UK),
69928471AZ (USA), available from our sales
network), and to operate as described in the sub-
section “Maintaining the charge”.
Keep the out of the reach of children.
Make sure the charger is OFF when you
connect the to it, or you might get sparks at
the terminals that could ignite the gases
inside the cells. Always connect the red positive (+)
terminal first.
Fig 181
228
To Next Page
Loading...
Need help?
General
